Dimmer switch 8-230VUC - Dimmer flush mounted EUD61M-UC

Dimmer switch 8-230VUC - Dimmer flush mounted EUD61M-UC – Eltako – 61100903 – 4010312107973: Dimmer switch 8-230VUC EUD61M-UC composition other, operating type touch operation, load type universal, light value memory, can be used with button, type of installation flush-mounted, type of fastening with screw, material plastic, material quality thermoplastic, halogen-free, surface other, design of the surface matt, color blue , rated voltage 230 ... 230V, control voltage 8 ... 230V, connection type screw terminal, wire cross-section 4 ... 4mm², device width 45mm, device height 45mm, device depth 18mm, min. depth of device socket 18mm, universal dimmer switch. Power MOSFET up to 400W. Automatic lamp detection. Standby loss only 0.1 watts. Minimum brightness adjustable. With children's room and snooze switch. For flush mounting. 45mm long, 45mm wide, 18mm deep. Universal dimmer switch for lamps up to 400W, depending on the ventilation conditions. Dimmable energy-saving lamps and dimmable 230V LED lamps also depend on the lamp electronics. Switching at zero crossing with soft on and soft off to protect the lamp. Universal control voltage 8..230V UC, electrically isolated from the 230V supply and switching voltage. Short control commands switch on/off, permanent control changes the brightness up to the maximum value. An interruption of the control changes the dimming direction. With the memory functions, the set brightness level remains stored when the device is switched off. In the on-max functions, it is always switched on with the maximum brightness level. In the event of a power failure, the switching position and the brightness level are saved and, if necessary, switched on when the supply voltage returns. Automatic electronic overload protection and over-temperature shutdown. The minimum brightness (fully dimmed) can be set with the upper %lamp rotary switch, eg for dimmable energy-saving lamps. Automatic mode allows all types of lamps to be dimmed. The lower function rotary switch can be used to select between five automatic operation functions: memory, memory+soft on, on max, on max+soft on and ESV+soft on. +ESL is a comfort position for energy-saving lamps, which, due to their design, have to be switched on with an increased voltage so that they can also be switched on again when dimmed when cold. -ESL is a comfort position for energy-saving lamps which, due to their construction, cannot be switched on again when they are dimmed. Therefore memory is switched off in this position. No inductive (wound) transformers may be used in the +ESL and -ESL positions. In addition, the maximum number of dimmable energy-saving lamps can be lower than in automatic mode due to the design. Function setting ESV like memory+soft on with setting of an off-delay of up to 90 minutes on the %lamp rotary switch if it was not switched off manually. At the end, switch-off pre-warning by dimming down within 1 minute. With children's room switch: When switching on by pressing the button for a longer period of time, after approx. 1 second it is switched on with the lowest brightness and, as long as the button is pressed, it is slowly dimmed up without changing the brightness level last saved. With snooze function: A double impulse dims the lighting from the current dimming setting down to minimum brightness and then switches it off. The maximum dimming time of 60 minutes depends on the current dimming position and the set minimum brightness and can be shortened accordingly. You can switch off at any time during the dimming process by briefly pressing the button. A long press during the dimming process dims up and ends the snooze mode. L loads (inductive loads, eg wound transformers) and C loads (capacitive loads, eg electronic transformers) must not be mixed. R loads (ohmic loads, eg 230V incandescent and halogen lamps) can be added as desired.