KNX analogue actuator 4-fold for the conversion of KNX telegrams to analog signals TYF684

TYF684 3250616059962 EAN/GTIN DE 23692311 WEEE

Our best price
£265.49 incl. VAT (£0.00)
£492.56 (-46.1% RRP***)

14-16 days* (GBR)

Safety and hazard information
Please note that electrotechnical work may only be carried out by qualified electricians or under their guidance and supervision. Observe any deviating country-specific electrical installation standards and regulations and seek advice from a local electrician.In addition, observe more current safety instructions and regulations for the products on the manufacturer's side or the product descriptions and installation instructions on the manufacturer's side.

Devices with a connected load of > 380V/400V require a heavy current connection and may only be connected by an approved electrical company. Devices with a power rating > 12kW require the approval of your grid operator (Germany, other countries may differ).
read more
show less
4-fold analog output TYF684 KNX bus system, other tebis TX bus systems, REG mounting type, width... more
KNX analogue actuator 4-fold for the conversion of KNX telegrams to analog signals TYF684 – Hager – 3250616059962: 4-fold analog output TYF684 KNX bus system, other tebis TX bus systems, REG mounting type, width in modular widths 4, basic module design, with LED display, with bus coupling, number of outputs 4, output current 0 ... 20mA, output voltage 0 ... 10V , degree of protection (IP) IP20, analogue actuator 4-fold REG KNX. Analog actuator receives KNX telegrams and converts them into current and/or voltage signals, e.g. for heating, air conditioning and ventilation technology. The actuator has 4 independent analog outputs. Type of signal output (0 to 10 V, 0 to 1 V, 0 to 20 mA, 4 to 20 mA) the output status can also be evaluated via status and/or switching object. The actuator can be expanded with the TYF684E expansion analog module with 4 additional analog outputs. The voltage outputs are monitored for short circuits. The actuator has a system interface for connecting the extension modules. The device has a programming button with a red LED. The two statuses are displayed via a green/red LED (operation/error). Bus connection via connection terminal. Connection of the outputs with screw terminals. The actuator requires a 24 V AC power supply for operation. Each channel can be programmed separately. Outputs that are not required can be switched off. The format of the input value is 8 bits or 16 bits. With dimming actuator operation, 8-bit for the input objects. Two forced operations can be carried out. The input variables are monitored cyclically. The response when the monitoring time is exceeded is adjustable. Behavior on bus voltage failure can be set, as can behavior on bus voltage recovery.
... more
Bus system KNX yes
Bus system KNX radio no
Bus system radio bus no
Bus system LON no
Bus system Powernet no
Other bus systems tebis TX
Mounting REG
Width in division units 4
Execution Base module
With LED display yes
With bus coupling yes
Number of exits 4
Output current 20 mA
Output voltage 0..10V
IP protection) IP20

Rate item

(0 reviews)
Read, write and discuss reviews... more
Customer review for "KNX analogue actuator 4-fold for the conversion of KNX telegrams to analog signals TYF684"
Write a review
Evaluations will be activated after verification.
Please enter these characters in the following text field.

The fields marked with * are required.