KNX switching actuator 20x or blind/shutter actuator 10-fold TYM620D

KNX switching actuator 20x or blind/shutter actuator 10-fold TYM620D – Hager – 3250616059498: Switching/blind output KNX 20/10f,16A CLast TYM620D bus system KNX, other bus systems without, mounting type REG, width in modular units 10, local/manual operation, with LED display, number of binary inputs 0, max. switching capacity 28750W, output power 2300W, suitable for C-load, max. number of switching outputs 20, max. switching current 16A, rated current 16A, rated operating voltage 230 ... 230V, different phases can be connected, with bus coupling, protection class (IP) IP20, switching/blind actuator 20/10 compartment KNX, 16A C load. Modular installation device with integrated bus coupler. Used to switch independent loads or to control drives and is equipped with potential-free NO contacts and can be connected in multiple phases. Switching or roller shutter/blind drive in up or down mode. To control lighting outputs, you can choose between ON/OFF, timer, safety off, forced control, blocking logic, preset delay function or 64 scenes. With switching function for time or permanent function. The movement command UP/DOWN/Stop and the slat angle can be adjusted via the blind function. Percent control of the blind to move to a predefined position. The sun protection function can be used in conjunction with an outdoor sensor to control the brightness in each room. With alarm function to control the blinds in a defined position. Safety descent as long as the button is pressed. 64 scene functions per channel. Logic block for controlling the output depending on the result of a logical operation. Preset locking function, forced control. The device converts the bus information into corresponding commands. The outputs are switched via the system line from the inputs assigned to them. Operating hours counter per output. The device can be read with a diagnostic tool. With programming button and red programming LED, bus connection via bus terminal, switching channels via box terminals. No external power supply necessary. With manual operation and LED switching status display as well as labeling options directly on the device. Note: The device can be programmed with the ETS (from version 4).