Weather data transmission module radio - Radio transmitter FWS61-24V DC

Weather data transmission module radio - Radio transmitter FWS61-24V DC – Eltako – 30000305 – 4010312301937: Radio weather data transmission module FWS61-24V DC radio frequency 868MHz, range 30m, wireless pushbutton on plaster, protection class (IP) IP20, other power supply, radio weather data transmission module for the seven weather data of the MS multisensor. With internal antenna. Standby loss only 0.3 watts. For flush mounting. 45mm long, 45mm wide, 18mm deep. Supply voltage 24 V DC from the 33 mm deep switching power supply SNT61-230V/24V DC-0.25A, also 45mm long and 45mm wide. This switching power supply also supplies the multisensor MS including the heating of the rain sensor. If necessary, put a deep flush-mounted box together for both devices. This weather data transmission module receives the seven currently recorded weather data brightness (from three points of the compass), twilight, wind, rain and outside temperature via cable JY (ST) Y 2x2x0.8 from the multi-sensor MS attached to the outside of the building and transmits them with the following Priority as radio telegrams in the Eltako wireless building. Only one multisensor MS can be connected to a wireless weather data transmitter module FWS61. However, several FWS61 can be connected to a multisensor MS. The external terminating resistor must only be present with an FWS61. On the other hand, it must be removed for further FWS61. The evaluation is carried out with the wireless building visualization and control software GFVS, the wireless multifunction sensor relay FMSR14, the actuators FSB14 and FSB71. When the supply voltage is applied, a teach-in telegram is sent immediately and after approx. 60 seconds two status telegrams with all the current values. Thereafter transmission at least every 10 minutes, but also under the following conditions: West, South and East brightness values each from 0 to 99 kLux with a change of at least 10%. Twilight values from 0 to 999 lux with a change of at least 10%. Wind speeds from 0 to 70 m/s. From 4 m/s to 16 m/s, the current values are immediately sent 3 times at intervals of one second and then further increasing values within 20 seconds. Decreasing wind speeds are sent with a 20-second delay. Rain 3 times immediately at start, within 20 seconds after ending. Temperature values from -40.0 °C to +80.0 °C every 10 minutes, together with all other values in a status telegram. Monitoring of the multi-sensor function and line break. If there is no weather data message from the MS multisensor for 5 seconds, the FWS61 sends an alarm telegram immediately and then every 30 seconds, which can be taught into an actuator as a button telegram in order to initiate further action if necessary. In addition, the two status telegrams with the values brightness 0 lux, twilight 0 lux, temperature -40°C (frost), wind 70m/s and rain are sent. If a message from the multisensor MS is detected again, the alarm stops automatically.