Router cascade - Multi switch for communication techn. TECHNIROUTER5/1x8KR

Router cascade - Multi switch for communication techn. TECHNIROUTER5/1x8KR – TechniSat – 0001/3291 – 4019588132917: Router cascade TECHNIROUTER5/1x8KR subscriber connections 8, number of inputs 5, cascadable, power supply without, control signal DiSEqC, The TechniRouter is the digital single-cable solution without a new cable! For the first time there is a single-cable solution without program restrictions. This has never happened before! Existing cable structures in residential properties can be upgraded with digital satellite signals from a satellite position without laying new cables. The digital single-cable solution without program restrictions! The TechniRouter is the digital single-cable solution without a new cable! For the first time there is a single-cable solution without program restrictions. This has never happened before! Existing cable structures in residential properties can be upgraded with digital satellite signals from a satellite position without laying new cables. What needs to be taken into account? Existing sockets, distributors and amplifiers must be replaced with satellite-compatible components. It should be noted here that all components have a DC bypass and the feed-through sockets in particular have two DC bypasses. The DC pass is required to transport the DiSEqC signal. The 13/18 V of the receiver is not needed as a switching command, but to transport the DiSEqC commands to the TechniRouter. Of course, the existing coaxial cables must also be checked for satellite suitability. The TechniRouter-compatible receivers control the TechniRouter basic unit and cascade digitally via DiSEqC level 1.0 with the EN 50494 protocol. This protocol is used to initiate and carry out the selection of the transponder frequencies/programs in the TechniRouters. The TechniRouter generates eight generated output frequencies in the IF frequency range 950-2150 MHz, through which individual participants can receive all digital programs without restrictions. Both low and high bands can be received. Up to eight participants can be served per TechniRouter. If eight connections are not enough, additional cascades can be connected to the basic unit. If more subscriber connections are required, or a combination with multiswitches (star cabling) is desired, this can be combined using multiswitches from the 5 or 9 series, as well as their accessories such as amplifiers, distributors or taps. Normal Quatro LNBs can be used. The TechniRouter basic unit supplies the operating voltage for the Quatro-LNB and also for any cascade connected upstream. The terrestrial signal path of the TechniRouters from this family is designed from the outset for the transmission of return path signals, so that the TechniRouters can be used as part of the transmission path between the cable network operator's home transfer point (HÜP) and the end customer's cable modem. Even if the advantages of satellite reception using an SCR single-cable system are used for television reception, they enable the simultaneous use of the already laid coaxial cables for Internet access and telephone via broadband cable, without having to install additional feed-in frequency switches. For this purpose, the Terrestrial input of the TechniRouter is usually connected to the HÜP.