Powerline repeater - Repeater for home automation PL-RPT

Powerline repeater - Repeater for home automation PL-RPT – Eltako – 31000030 – 4010312324103: Powerline repeater PL-RPT bus system Powernet, other bus systems without, mounting type flush-mounted, nominal voltage 230V, protection class (IP) IP20, powerline repeater. 53x43mm, 25mm deep, for mounting in 58mm switch boxes. Stand-by loss only 0.5 watts. Greater ranges can be achieved with the repeater. For cable lengths >300m, the repeater is typically placed in a distribution between the sensor and actuator. The repeater repeats commands from sensors with the same address g, e. Feedback from the actors is not repeated. There are two rotary switches on the front for address assignment: The left rotary switch determines the group address g with 16 alphabetic values from A to P. The right rotary switch determines the elementary address e with 16 numerical values. Above it there is a slide switch as a configuration switch with positions 0, 1 and 2. Position 0: Central commands are repeated, depending on the address e of the repeater. At address g, e = 0 only central commands are repeated. Position 1: If address g, e = 0 on the repeater, all commands of group g are repeated. Position 2: Not used. Addresses can be changed under voltage or without voltage. To the left of the rotary switches there is a red LED that shows all activities. Next to it is the reset button and to the right of it is a service pin (P). The connection terminals at the top are plug-in terminals for conductor cross sections from 0.2mm² to 1.5mm².